LCD Display Module Adapter PCB for arduino Nokia 5110

Description

Features:

• 84 X 84 dot matrix LCD,can show 4 lines of characters
• Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.
• LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
• Low power supply,the working current in normal situation is lower than 200μA,and has power-down mode

Specification

Note:

• LIGHT linked with GND, the backlight to be lit.
• Use a 3.3V controller, otherwise the display can damage

LCD5110 Module:

• RST——— reset
• CE————chip selection
• DC———–data/commands choice
• DIN———–serial data line
• CLK————serial Clock Spee
• 3.3V————VCC.
• LIGHT——— back light control terminal.
• GND———–power negative.