LCD Display Module Adapter PCB for arduino Nokia 5110

Already 2 persons shown interest.

LKR 650.00

Out of stock

Description

Features:

  • 84 X 84 dot matrix LCD,can show 4 lines of characters
  • Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.
  • LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
  • Low power supply,the working current in normal situation is lower than 200μA,and has power-down mode

 

Specification

Note:

  • LIGHT linked with GND, the backlight to be lit.
  • Use a 3.3V controller, otherwise the display can damage

LCD5110 Module:

 

  • RST——— reset
  • CE————chip selection
  • DC———–data/commands choice
  • DIN———–serial data line
  • CLK————serial Clock Spee
  • 3.3V————VCC.
  • LIGHT——— back light control terminal.
  • GND———–power negative.

Additional information

Weight 20 g

Reviews

There are no reviews yet.

Be the first to review “LCD Display Module Adapter PCB for arduino Nokia 5110”